Chorus, 09; chorus – KORG Soundlink DRS REcording Console 168RC User Manual

Page 59

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Chapter 4. Effects

09: Chorus

This is a stereo-output harmonic chorus. The left and right LFOs can be biased to control the

spaciousness.

If0 TYPE

Triangle, Sine '

Select the LFO waveform.

LFO PHSE

-180...+180 deg

Set the phase difference between the left and right LFOs.

If the phase of the LFOs is biased, modulation will be ap
plied to the left and right "out of step" with each other. This

will produce a more spacious feeling, and the processed

sounds in the left and right will "beat" against each other.

LFO FREQ

0.02... 15.0 Hz

Set the LFO speed.

DPTH

0...100

Set the modulation depth of the LFO.

W/D

Dry,!...99, Wet

Set the balance between the effect processed sound and
the direct sound.

PreDLAY

0...200mS

Set the delay time after the direct sound.

FBAK

-100...+100

Set the amount of feedback for the chorus block. Raising
the feedback will produce a flanging effect.

DAMP

0...100

Set the amount of high frequency attenuation for the cho

rus block.

Split FREQ

100Hz...10.0kHz

Set the frequency at which the low and high frequencies
will be split. Only the high frequency range will be sent to
the chorus block.

Split LOW

0...100

Set the output level of the low frequency range.

Split HIGH

0...100

Set the output level of the high frequency range (the cho
rus sound).