KORG Soundlink DRS REcording Console 168RC - Manual (Page 12)

2. Controls and their functions
0 [l/S/Pl (Input/Send/Pan) key
This key accesses I/S/P mode, in which you can select audio input sources, and set phase, pan,
and send level etc. The volume (channel faders), solo, and muting for channels 13-16 are set in
this mode. An input level meter is displayed.
0 [EQ] key
This key accesses EQ mode, in which you can make 3-band parametric EQ settings and turn EQ
on/off for channels 1-12. 30 EQ settings can be named, stored and recalled into any mix.
0 [BUS] key
This key accesses BUS mode, in which you can make settings to assign channel signals to master
L/R and the group buses.
0 [INPUT] key
This key accesses INPUT mode, in which you can select the audio input sources for each analog
and digital channel, and invert the phase of the input signals.
0 [AUX SND] key
This key accesses AUX SND mode, in which you can set the level of the Aux 1 and 2 sends for
channels 1-16. Settings for all channels are displayed at once, and 8 channels can be adjusted
simultaneously. In I/S/P mode, these settings can be made for individual channels.
0 [EFF SND] key
This key accesses EFF SND mode, in which you can set the level of the Eff 1 and 2 sends for
channels 1-16. Settings for all channels are displayed at once, and 8 channels can be adjusted
simultaneously. In I/S/P mode, these settings can be made for individual channels.
0 [PAN] key
This key accesses PAN mode, in which you can set the panning for channels 1-16. Settings for all
channels are displayed at once, and 8 channels can be adjusted simultaneously. In I/S/P mode,
these settings can be made for individual channels.
0 [EFF 1] key, [EFF 2] key
These keys access EFF 1,2 mode, in which you can make settings for the internal effects. You can
modify the settings of the internal effects processors, turn the effects on/off, and specify the desti­
nation of the effect outputs. A total of 50 effects can be stored.
0 [BUS MASTER] key
This key accesses BUS MASTER mode, in which you can adjust the volume of the group buses,
and turn on/off the signal sent to the master bus.
0 [SND MASTER] key
This key accesses SND MASTER mode, in which you can select the signal that will output for
monitoring, and adjust the level of each bus.
0 [METERS] key
This key accesses METERS mode, in which the channel meters and bus meters are displayed. The
master L/R level is indicated by the master level meter 0.
0 [RECALL] key
This key recalls a program. Programs can also be recalled in PGM mode.
0 [SAVE] key
This key saves a program. Programs can also be saved in PGM mode.
0 LCD
This displays parameter values and other information.
0 Knobs [1]...[8]
Use these knobs to select parameters in the LCD or to modify their value («s’ p.l4).
© [ /\ ] key, [ \/ ] key
Use these keys to select a line in the display (the line of highlighted values etc. in the LCD) f'®’ p.l3).
0 [+] key, [-] key
Use these keys to modify the value of a parameter in the LCD f'®' p.l4).
0 [c] (Cycle) key
Pressing this key will take you back to the previously selected mode. Pressing it once again will
return you to the original display f“® p.l5).