KORG Soundlink DRS REcording Console 168RC - Manual (Page 21)

Chapter 1. Basics
O Modify parameter values
In the group of knobs located below the LCD, rotate or press the knob which corresponds
to the desired parameter in the selected line to modify its value. After a parameter has been se­
lected, you can also use the [+] and [-] keys to modify its value. However this operation will
depend on the type of parameter.
In INPUT, AUX SND, EFF SND and PAN modes, you can also select parameters by pressing the
[SEL] key of the channel that you wish to edit.
Madifying fhe value of a knob icon
Rotate the knob located below the LCD that corresponds to the desired parameter.
However if you move to a different line or recall a program, the position of the knob will no longer
correspond to the position of the knob icon in the LCD, and rotating the knob will not change the
value. In this case, use one of the following two methods.
© Press the knob, and then rotate it.
When you press the knob, the current position of the knob will be assigned as the value. Then as
desired, rotate the knob or press the [+] and [-] keys to modify the value.
Example: Setting Pan to "L50" when it was at "CNT"
When the knob was in the position shown in the illustration, rotating the knob full left and then
pressing it will set the value to L50.
p.OO*
‘O "O ^ “'O
JBgni HSM IBifii HSM
9Q IIQ 12Q
CNT CNT CNT CNT
© Rotate the knob to match the setting, and continue rotating it.
If you rotate the knob without pressing it, the value will not change until the knob reaches the
position of the knob icon in the LCD. After the position of the knob matches the position of the
knob icon, the value will change continuously. After the positions have been matched, you can
also modify the value by using the [+] and [-] keys.
Example: Setting Pan to "R50" when it was at "CNT"
If the knob was rotated fully left, rotate it to the right. The value will not change tmtil the knob
reaches the center (CNT) position. As you continue rotating the knob, the value will continue to
change until it reaches R50.
'O XD X!)
jimsfsm HM IBM HM
9Q HQ 12Q
CNT CNT CNT CNT
14