Signal flow and mode, Analog inputs Page 16
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Signal flow and mode
3.
Signal flow and mode
The following diagram is a simple depiction
of the
168RC's internal signal flow.
MON L
MON R
Analog inputs
The 168RC has 10 channels of analog input. The eight channels INPUT A~D and LINE IN E~H are
input to the mixer, and the TAPE IN L/R can be sent via a select switch directly to the monitor/
headphone output in an analog state.
INPUT A~D are for either mic or line inputs, and LINE IN E~H are only for line inputs. INPUT A
and B are XLR connectors which allow phantom power to be supplied.
INPUTS A~D provide PAD and TRIM (A and B provide phantom power) and LINE IN E~H
provide TRIM to adjust the level before the signal enters the digital domain.
Digital input
The 168RC has 16 channels of digital input. Both the adat OPTICAL IN A and B inputs can be used
simultaneously. If the two outputs are being sent from different devices, the sampling frequency
must be precisely matched. Refer to the T. System connection examples' («s’ p.82) included at the
end of this manual.