KORG Soundlink DRS REcording Console 168RC - Manual (Page 38)

3. MIDI mode
The following parameters from Tx Base Ch through MIDI Type, which are marked by will be
set automatically when you make a selection for this System Extension parameter, but you may
modify the values if your system needs are more complicated. Be aware that the settings of these
parameters will be modified when you select a different System Extension setting.
Devicelo "01... 16"
This is an ID number used when exchanging System Exclusive messages. This number is used for
both transmission and reception. The device ID numbers must match on both master and slave
devices when using a Remote or Duplicate setting, or on both the transmitting and receiving
devices when performing a data dump.
TxBaseCh** "01... 16"
This is the channel on which MIDI messages other than System Exclusive messages are transmit­
ted.
RxBaseCh** "01... 16"
This is the channel on which MIDI messages other than System Exclusive messages are received.
MIDI Type** "Off, Control Change, NRPN, Exclusive"
Select the type of MIDI message with which the 617 parameters such as fader and pan which
allow realtime control will be transmitted and received.
Off: MIDI messages will not be transmitted or received.
Control Change: MIDI messages will be transmitted and received using Control Change mes­
sages.
NRPN: MIDI messages will be transmitted and received using NRPN (Non Registered Param­
eter) messages.
Exclusive; MIDI messages will be transmitted and received using System Exclusive messages.
System exclusive messages will not be transmitted until you exit the MIDI Setup page.
Program Change Tx "Off, Program, Progrom,Eff, Progrom,Eff,EQ"
Program Change Rx "Off, Program, Program,Eff, Program,Eff,EQ"
Select the way in which Program Change messages will be used. Program Change messages will
not be transmitted or received if the MIDI Type is "Off" or "Exclusive."
Off: Program Changes will not be used.
Program: They will be used to recall programs.
Program,Eff: They will be used to recall programs, and read effect memories.
Program,Eff,EQ: They will be used to recall programs, read effect memories, and read EQ memo­
ries.
Program Change No. "Default, User"
Select the way in which Program Changes will correspond to the program numbers of the 168RC.
Default: The program change number will match the program number of the 168RC.
User; The program change numbers specified by Program Mapping will be used.
Parameter Number "Typel, Type2, User"
Specify how 168RC parameters will correspond to control change numbers.
Typel: One 168RC will use 7 channels. Control change numbers 0~95 will be used.
Type2: One 168RC will use 8 channels. Control change numbers often used by synthesizers etc.
will be avoided (‘®’ p.79).
User: You may freely select from all channels and control change numbers.
[EXIT]: Return to the MIDI MENU page.
Program Mapping (Prog. Map)
000
tmi
002
003
004
>Pro9.Map
00 SCENE 01
[mSCENE 02
02 SCENE 03
03 SCENE 04
04 SCENE 05
[P.N q ]
005
006
007
008
009
05 Guitar01
06 Guitar02
0? Guitar04
08 Oocaltrack
09 Chorustrck
[EXIT
31