KORG Soundlink DRS REcording Console 168RC - Manual (Page 51)

Chapters. Parameters
14. SND MASTER mode
Monitor
Mstr
O
P
[US
Auxl Aux2 E f f l E f f 2
Q) O 51 Ql
ms ms ms [US
Grp.Link
51
ms
G15 G2S1 G35 G45 G551 G65 G?5 G85
OFF OH OFF OFF OFF OFF OFF OFF
Select the signals that will be output to the monitor. The same signals will be sent to the head­
phones. The monitor output is also affected by the [TAPE IN/MONITOR] switch of the front
panel. In order for the setting you make here to be effective, this [TAPE IN/MONITOR] switch
must be in the MONITOR position.
Mstr, Auxl, Aux2, Effl, Eff2 "OFF, ON"
With an "ON" setting, the signal will be output to the monitor. Mstr is output to the monitor in
stereo. Auxl and Aux2 are monaural. Effl and Eff2 output the signal that is processed by the
effects.
Grp,Link,Gl...G8 "OFF, ON"
If you wish to monitor the group buses in stereo, turn Grp.Link "ON."
When Grp.Link is "ON," you can select the monitored signal from the four pairs G1 /2, G3/4, G5/
6 and G7/8.
When Grp.Link is "OFF," you can monitor just one group G1-G8 in mono.
Mstr.Level
set PGM
Solo L R i Auxl Aux2
O 121
MON+ Pre
>Mstr.Le'...'el
E f f l E f f 2
^iOiSIlSQ I №0
5
OFF
5
OFF
IQ) ca
OFF OH
Solo "0...100"
This sets the level of the Solo bus.
INDV/MON+ "INDV, MON+"
When monitoring a soloed signal, this switch specifies whether it will be combined with the pre­
viously-monitored signal. With a setting of "MON+", the sound of the solo bus will be added to
the sound of the monitor bus. The monitor bus signal will be attenuated by -12 dB. With a setting
of "INDV," only the sound of the solo bus will be heard.
Pre/Post "Pre, Post"
This selects whether the soloed signal will be taken from before the fader ("Pre") or after the fader
("Post"). This setting is common to all channels.
Auxl, Aux2, Effl, Eff2 "0... 100", "ON, OFF"
These set the levels of the Auxl, Aux2, Effl and Eff2 buses.
The "ON/OFF" switches are mute switches for each bus. With a setting of "OFF" the bus is muted.
44