KORG Soundlink DRS REcording Console 168RC - Manual (Page 44)

6. EQ mode
EQ Memory
Kick Druml
02:Kick Drum2
l
07:
03: 08:
04: 09:
05: 10:
URITE] [LQCKliNAME] [RE8D][EXIT](<^/'t-)
Here you can manage EQ memories. Up to 30 EQ memories can be used.
Write [WRITE]:
Write (save) the EQ settings of the current channel into the highlighted EQ memory. Any settings
which were previously in that EQ memory will be lost and overwritten.
O Press a [SEE] key to select the channel whose EQ you wish to write into EQ memory.
O Highlight the writing destination, either by rotating knob [8] or by using the [ /\ ]/[ \/ ]
keys.
O Press knob [1] ("[WRITE]"). The display will ask "Are You Sure? [YES] [NO]."
O If you wish to write the data into memory, press knob [5] to execute the write operation. If you
decide not to write, press knob [6].
Lock [LOCK]: This will protect the EQ memory so that it cannot be overwritten.
O Highlight the EQ memory that you wish to protect, either by rotating knob [8] or by using the
[ /\ ]/[ V ] keys.
O Press knob [3] ("[LOCK]")- A "L" symbol will appear at the right of the EQ memory name, and
it will no longer be possible to save data to that memory. If you select "[LOCK]" once again,
the "L" symbol will disappear, and it will once again be possible to save data to that memory.
Name [NAME]: This lets you modify the EQ memory name.
O Highlight the EQ memory that you wish to rename, either by rotating knob [8] or by using the
[ ^ ]/[ V ] keys.
O Press knob [4] ("[NAME]"), and the EQ Name page will appear. For the procedure of modify­
ing the name, refer to the "Prog.Name" item that was discussed earlier in this chapter.
Read [READ]:
This reads the highlighted EQ memory into the EQ of the channel you specify.
O Highlight the EQ memory that you wish to read, either by rotating knob [8] or by using the
[ /\ ]/[ V ] keys.
Q Press a [SEL] key to specify the channel into which the EQ settings will be read.
Q Press knob [6] ("[READ]") to execute the read operation. When this operation is executed, the
EQ settings of that channel will be overwritten and lost.
Exit [EXIT]: Exit's the Ch EQ page.
EQ Name
Here you can modify the name of a memory.
EQM.01: K i c k Drum1
ABCDEFGHIJB-MN OPQRSTUUUXVZ 0123456789
abode f 9h i J k
1
mn op^rstuuwxy z !" '
+-?3
[>] ¡SHFT] («) (») [SEL.llENTRl
For the procedure of modifying a name, refer to the "Prog.Name" item that was discussed earlier
in this chapter.
37