Brother INTELLIFAX 3650 - Manual (Page 34)

I tLtHHUIMh hUNU I lUN bt 11ПМУЬ
4
.
FUNCTION SETTINGS
There are some settings, such as the date and time, you should set on your fax machine before
you begin using it. Once entered, these settings will remain in the machine until you change them.
You can begin customizing the settings by pressing Function on the control panel. This activates
the function mode and On-Screen Programming prompts. You can complete a variety of settings
in this mode.
Setting the Dialing Mode (TonelPulse) ____________________________
Your fax machine supports both tone (multi-frequency) and pulse (rotary) dialing. It is initially
set to TONE, so you do not have to change the setting if you use that kind of line. If you are using
a pulse dial line, you can change the setting to PULSE by following the steps below:
1. Press Function.
You will see scrolling options on the
display. You can choose one.
2. Press 6
.
3. Press 1.
After two seconds you will be prompted
to select pulse or tone.
4. Press (left arro^v) or (right
arrow) to find the dialing mode
that matches your telephone line.
Example: PULSE.
5. Press Set.
6. Press Stop to return to the date
and time.
L O l / q i / 1 9 9 9 0 0 : 0 0 J
( 1 . T E M P . S E T T I N G S )
i 6 . T E L O P T I O N S ]
c ( l . T O N E / P U L S E
[ D I A L I N G : T 0 N E
i S E L E C T < - - > & S E T )
( D I A L I N G : P U L S E )
: )
( l . T O N E / P U L S E
Setting the Beeper Sound Level
If the beeper setting is LOW or HIGH, it will “beep” every time you pre.ss a key, make an error,
or at the end of sending or receiving a fax.
The initial setting on your fax machine for the beeper is LOW. If you do not want the beeper on,
select OFF, and if you want it loud, select HIGH.
26