Remote control commands, Printing a fax message, L^hmote fax options remote control commands – Brother INTELLIFAX 3650 User Manual
Page 101
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
l^hMOTE FAX OPTIONS
Remote Control Commands
You can control your fax machine with the following remote control commands.
Remote control command
Operation Detail
95
Changing Fax Forwarding
/Paging setting
1 OFF
If you hear one long beep, the change is accepted. If you hear three
2 Fax Forwarding
short beeps, you can not change it because the conditions (ex.
registering fax forwarding or paging number) have not been com
pleted. You can register your fax forwarding number by using 4.
FAX FWD No. (see page 94). Once you have registered the number,
the machine automatically will turn to FAX PWD,:ON mode. To
3 Paging
4 FAXFWDNo.
5 FWD No. Confirm
receive a Memory Status List, enter 961 (see page 94). Check the List
to make sure the Pax Forwarding number you registered is correct.
Then enter the confirmation command 955. Now the machine will
start Fax Forwarding.
6 Fax Storage ON
You can set FAX STORAGE ON or OFF.
7 Fax Storage OFF
96
Retrieve FAX
1 Memory Status List
You must call from a remote fax machine to receive the Memory
Status List or stored fax message(s). (See page 94.)
2 00 Retrieve all FAXES
2 “MSG No." 00
Retrieve by MSG
number
3 Erase FAX in the
memory
If you hear one long beep, you can erase fax message(s) from the
memory.
97
Check the receiving status
You can check whether your fax machine has received any fax
message(s). If yes, you will hear one long beep, If no, you will hear
three short beeps.
1 FAX
98
Change Answer Mode
If you hear one long beep, you can change the Answer Mode. If you
hear three short beeps, you can not change it.
1 TAD
2 F/T
3 Fax
90
Exit
After a long beep, you can exit remote control.
Printing a Fax Message
You can print a fax message tliat is stored in the memory.
1. Press Function.
2. Press
8
.
3. Press
4.
4. Press
Start.
5. Press
Stop
to exit.
THE DISPLAY WILL SHOW:
( F A X I N M E M 0 R Y : 0 3 )
( 1 - T E M P ■ S E T T I N G S )
( 8 ■ R E M O T E F A X O P T )
(
4 , P R I N T
F A X
1
( P R E S S S T A R T K E Y )
( P R I N T I N G )
( 4 . P R I N T F A X
93