Brother INTELLIFAX 3650 - Manual (Page 27)

HnWTD IJSF ON-SCRFFN PROGRAMMING (OSP) AND HELP KEY
Level one
function
Level two
function
Explanation of Options
Factory
setting
Page
4. CONTRAST
There are three types of contrast settings.
Usually the AUTO setting is acceptable. But
if you want to send or copy an especially light
or dark document, you should change this
setting.
AUTO; Default setting is AUTO. Contrast
setting always reverts to AUTO after
one transmission.
S. LIGHT: To send very light documents.
S. DARK: To send very dark documents.
AUTO 39
1.TEMP.
(TEMPORARY)
SETTINGS
5. RESOLUTION
If you need to send a set of originals at
various resolutions, this function will allow
you to set the required resolution page by
page. (If all documents are the same
resolution, use the Resolution key. See page
17 #21.)
STANDARD/FINE/S. FINE/PHOTO
STAN­
DARD
50
6. OVERSEAS
MODE
If you have trouble when sending overseas,
you may want to set OVERSEAS MODE to
ON.
ON/OPF
OFF 49
7, COVERPAGE
An automatic Cover Page will allow you to
send details of who the fax is going to, who it
is from and when it was sent. ON/OFF
OFF 51
8. REAL TIME TX
You can temporarily send the documents in
real time without using memory.
ON/OFF
OFF 42
2. REMAINING
JOBS
You can check or cancel jobs that are in the
memory to be sent or polled
47-48
3. PRINT
REPORTS
See page 96 for
a list of reports.
You can print several different lists and
reports, which are available under function
item 3. PRINT REPORTS.
95-99
1. ONE-TOUCH
DIAL
If you register names and numbers on One
Touch dial keys, you can dial a number
automatically just by pressing a One Touch
key. (Max. of 40 locations)
— 29-30
4. SET AUTO
DIAL
2. SPEED-DIAL
If you register names and numbers as Speed
Dial numbers, you can dial a number
automatically just by pressing the Speed
Dial key and a two-digit number. (Max. of
100 locations)
— 31 32
3. SETUP
GROUPS
This is used for setting up a group number
used for broadcasting.
33-34
19