Brother INTELLIFAX 3650 - Manual (Page 100)

khIVIUIh hAXUPMUNS
How to Use Remote Access and Control Codes
1. Pickup the handset of a touch tone phone.
2. Enter your fax machine’s number.
3. When your fax machine answers with a beep, immediately press your Remote
Access Code 159* (factory setting). (See page 91.)
4. If you hear a long beep, it means your machine has received fax message(s).
If you do not hear a long beep, it means your fax machine did not receive
message(s).
5. As soon as you hear two short beeps, press a Remote Control Command. (See
page 93.)
Each time your fax machine completes an instruction, it gives two (2) short beeps
telling you to enter the next command, if you wait longer than 30 seconds to enter
the command, your machine will disconnect the line. If you perform a wrong
operation, you will hear three (3) short beeps.
6. When you are ready to exit remote control mode, press 90 to reset your machine.
Remote Retrieval _________ ____________________________________
If you have set your FAX STORAGE: OM to store incoming fax messages, you have the ability to
retrieve these fax messages from any remote group 3 facsimile machine.
Remote fax retrieval is accomplished via remote control access commands, which are described
in the remainder of this chapter.
FOR YOUR INFORMATION
When to Press the Remote Access Code
Just after the line is connected, you should enter the remote access code from any
touch tone phone. Make sure that you enter the remote access code while you do NOT
hear any chirping sound of a fax machine. If the fax machine is set to MANUAL
mode, it will answer the call after about 20 rings (about 100 seconds). You will have
30 seconds to press the remote access code or the line will be disconnected.
92