Command list – A&D Weighing HW-200KV-WP User Manual
Page 64
Page 62
HV-WP/HW-WP Series
17.3. OP-04, Options
17.3.3. Command
List
The following explanation uses "Format 1 ( f15 3 )" assuming 23 as the address.
Data output
The current weighing data is output.
Template Q
Command
Reply
Selection of mode and unit
Selects the mode and unit. This is the same as the
MODE
switch.
Template U
Command
Reply
The scale changes mode and unit.
Zero
The current mass value is set to the zero point.
This is the same as the
ZERO
switch.
Template Z
Command
Reply
The mass value becomes zero and the zero point mark is displayed.
Tare
The current mass value becomes zero after placing a tare (receptacle, case, etc) and
the net is displayed. This is the same as the
TARE
switch.
Template T
Command
Reply
The current mass value becomes zero and the net mark is displayed.
Cancel of tare
The display value becomes the gross and the net mark is turned off. (The tare value
becomes zero.)
Template CT
Command
Reply
Gross is displayed and the net mark is turned off.
Preset tare
The tare value is set and the net value is displayed. The set value is a 5 digit
numerical value with a polarity sign and does not contain a decimal point.
Template PT,
[parameter]
Command
Reply
Net is displayed and the net mark is displayed.
Upper limit value
An upper limit value is stored.
The set value is a 5 digit numerical value with a polarity
sign and does not contain a decimal point.
Template HI,
[parameter]
Command
Reply
The upper limit value is stored.
Caution
The upper limit value must be greater than the lower limit value.