A&D Weighing HW-200KV-WP - Manual (Page 23)

HV-WP/HW-WP Series Page 21 7. Basic Operation
Explanation
The status of "Inactive comparator ( f6 )" is that comparator function ( f6 0 , f6 2 , f6 4 , f6 6 )
is selected and the comparator is not used. The "active" or "Inactive" (ON/OFF) for the
comparator can be selected by pressing the SET switch alternately.
The following parameters are stored in the same memory. Therefore, the functions
can not be used at the same time. If you use each function, it will be necessary to
select the function from the function table, to set the parameters of HI,OK and LO, to
weigh it using the function.
Indicator and Output
HI OK LO
Upper/Lower Comparator Function ( f6 0 ~ 7 ) Upper limit Lower limit
Simple Batch Function ( f6 8 ) Final value
Preliminary
value
Zero band
Full/ Dribble Batch Function ( f6 9 ) Final value
Preliminary
value
Zero band