A&D Weighing BM-500 Addendum - Manual

1
BM Series Additional Information
Overview
(Supported software versions: P-1.20 and later)
This supplementary manual describes functions that have been added to the BM series.
□ Temperature measurement during weighing:
The balance has an embedded temperature sensor.
The temperature of the setup environment of the balance can be displayed and output.
Measurement precision is ±1.5 °C (between 5 and 40 °C).
*The result is temperature inside the balance.
□
External control of the static charge eliminator (Ion function):
By connecting an AD-8922A remote controller or using the external input on the rear of
the balance, the static charge eliminator can be switched on and off without needing to
press a button on the balance.
Displaying the Temperature
□ In the weighing mode, press the SELECT key.
The display shows each of the following items for 5
seconds in the following order: time, date, and
temperature. After all items have been displayed,
the display returns to the weighing mode.
To proceed to the next item while an item is
displayed, press the SELECT key.
* The unit for display is °C.
Outputting the Temperature
□
To add the temperature to the weighing data output, select the “ dout ” (data output) settings and
change the “ 5-tp ” (add temperature) setting.
Temperature output setting (added after the setting “ar-d”)
■
off Not used ar-d
Zero after output
on Used
■
off Do not output temperature
dout
Data
output
5-tpP
Add temperature o n Output temperature
■
Factory setting
Data format for temperature output
Temperature dout 5 -tpP on *The unit for output is “C”.
1
+ 0 2 3 . 4 C C
R
L
F
Weighing mode
Press SELECT .
Time display
Wait 5 seconds or press SELECT
Date display
Wait 5 seconds or press SELECT
Temperature display
Wait 5 seconds or press SELECT
Weighing mode
New
1WMPD4002332