A&D Weighing HW-200KV-WP - Manual (Page 19)

HV-WP/HW-WP Series Page 17
7. Basic Operation
7.1. Turning the Scale on/off and Weighing
Step 1 Ground the scale using the earth terminal.
Step 2 Place nothing on the weighing pan.
Step 3 Confirm that local voltage and receptacle type adapt to your scale.
Step 4 The scale turns on/off using the
ON/OFF switch alternately.
Step 5 Check the accuracy of weighing. If you calibrate the scale, perform it after turning
the scale on for 30 minutes (warming up).
Step 6 Press the ZERO switch to display zero. (with nothing on the weighing pan.)
Step 7 Place an item on the weighing pan gently.
Step 8 You can read the mass value after the stability mark is displayed.
Step 9 Remove the item from the weighing pan.
Step 10 Turn the scale using the
ON/OFF switch off.
Memo
With the power cord connected, the scale consumes only the power for standby
status after turning off the scale. To shut down the power completely, disconnect the
power cord.
7. Basic Operation