Example of setting parameters – A&D Weighing HW-200KV-WP User Manual
Page 57
HV-WP/HW-WP Series
Page 55
16. RS-232C Serial Interface
16.3.2. Example of Setting Parameters
Step 1 Turn off the display.
Press
the
ON/OFF
switch while the
ZERO
switch is
pressed and held. The function table is displayed.
Step 2 Press the
ENTER
switch to display f4 ("Baud rate").
Select a parameter of "Baud rate" with the
∧
switch.
Step 3 Press the
ENTER
switch to display f5 ("Output
mode").
Select "Command mode ( f5 1 )" with the
∧
switch.
Step 4 Press the
ENTER
switch to display f15 ("Format").
Select "Format 1 ( f15 0 )" with the
∧
switch.
Step 5 Press the
ENTER
switch to display end .
Step 6 Press the
ENTER
switch to store the new parameters.
The scale returns to the normal weighing mode.
Step 7 When the computer transmits a command, the scale
replies.
P r e s s and hold
Press
Fun c t i o n t a b l e
D i s p l ay off
Bau d r a t e
Comm a n d m o d e
F o r m a t 1
W e i g h i n g value