beautypg.com

Installing the scale – A&D Weighing HW-200KV-WP User Manual

Page 10

background image

Page 8

HV-WP/HW-WP Series

5. Installing the Scale

5. Installing the Scale

This procedure includes all of the steps for installing the HV-WP series and HW-WP

series. Therefore, on some models, there are some unnecessary steps.


Step 1 Connect the indicator unit to the pole with the

accesory knobs and rubber washers.


Step 2 Take the base unit and pole out, taking care

that the load-cell cable is not pulled.


Step 3 Put the weighing pan on the base unit.

Step 4 Attach the pole to the bracket of the base

unit so as not to damage the load cell cable.
Insert the remainder of the load cell cable
into the pole. Affix the pole to the bracket
using two 3mm Allen screws.


Step 5 Select the place for installing the scale. Also

consider "4. Caution" on page 7.



Step 6 Adjust the level of the base unit by using the

"Bubble spirit level" and "Leveling feet".


Step 7 Ground the scale using the earth terminal.

Caution

Please confirm that the local voltage and
the receptacle type are correct for your
scale.


Step 8 Adjust the angle of the indicator unit using

the knobs on the side of indicator unit.


Step 9 Check the weighing accuracy. If the scale

needs calibration, refer to "14. Calibration".
on page 40.

Step8

Knob

Power terminals

Earth terminal

Step7

Earth

Earth

Base unit

Pole

Load-cell cable

Pan

Step 3

Step 2

3mm allen screws

Step 4

Allen wrench

Pole

Bracket

Bubble spirit level

Leveling feet

OK

NG

Step 6

Power label

Knob

Pole

Cable

Indicator

Rubber washer

This manual is related to the following products: