Outputting the density – A&D Weighing GF-32K User Manual
Page 80
78
Entering the density directly (
ldin 1
)
The density currently set (unit : g / cm
3
, factory setting : 1.0000g / cm
3
) is displayed.
Use the following keys to change the value.
The range to set the density is 0.0000g / cm
3
to 1.9999g / cm
3
.
RE-ZERO
key...To set the value of the digit selected.
SAMPLE
key ....To select the digit to change the value.
key........To store the change, display
end
and return to the density mode.
(Go to "Step 2 Selecting a parameter to set")
CAL
key...........To cancel the change and return to the density mode.
(Go to "Step 2 Selecting a parameter to set")
Outputting the density.
Step 4 After all the necessary parameters have been set, press
the
SAMPLE
key to output the density calculated.
The density is displayed with three decimal places.
Calculated result