A&D Weighing GF-32K - Manual (Page 44)

42
10-5-1. Description of the Data Format Added to the Weighing Data
ID number dout 5-id 1
The number to identify a specific balance.
This format consists of seven characters excluding the terminator.
Data number dout d-no 1
This format outputs the data number just before the data is transmitted using the RS-232C
interface.
This format consists of six characters excluding the terminator.
When CSV format (
5if type 5 ) is selected, the period ( . ) is replaced with a comma ( , ).
Date dout 5-td 2 or 3
The date output order can be changed in "Clock ( Cl adj )".
The year is output in a four-digit format.
Note
GF-K series does not use this format.
Time dout 5-td 1 or 3
This format outputs time in 24-hour format.
Note
GF-K series does not use this format.
Tare value
When the tare value in memory is recalled, the tare value is output before the weighing data.
Comparison results
By setting "Comparison results ( Cp-r )" of the function table to " 1 ", the comparison results
can be added to the data output using the RS-232C serial interface. Use A&D standard
format (
type 0 ).
The comparison results are added after the header in A&D standard format as below.
Note
When the data described above is added to the weighing data, the output is in the
following order: ID number, Data number, Date, Time and Weighing data.
Data number Terminator
Tare value recalled from memory
Net value
Header Data Unit Terminator
Comparison result
When the comparison result is HI
When the comparison result is OK
When the comparison result is LO
Not applicable