KEYENCE SL-CHG Series - Manual (Page 9)

Chapter 1 Overview and Specifications
1-1
1
ENGLISH
1 Overview and Specifications
1-1 Component Names and Units
This section describes each part of the SL-CHG Series and optional units.
For component locations and appearances
, ➮ see the “1-4 Dimensional Drawings” (page 1-5).
1-1-1 Main System and Cables
When using the SL-CHG stand-alone
Detection zone
SL-C HG Transmitter
Status indicator
(on both sides)
SL-P7 (P) G (7 m (22.97 ft.)) cable
for transmitter (gray)
SL-P7 (P) G (7 m (22.97 ft.)) cable
for receiver (black)
SL-C HG Receiver
When combining the SL-CHG with a controller
SL-CHG Series + SL-U2 (Dedicated power supply unit) + SL-R11G (Intelligent safety relay unit)
SL-U2
SL-R11G
SL-PC5PG (5 m (16.4 ft.)) cable for transmitter (gray)
* 10 m(32.81 ft.) SL-PC10P cable
SL-PC5PG (5 m (16.4 ft.)) cable
for receiver (black)
* 10 m(32.81 ft.) SL-PC10P cable
Detection zone
SL-U2: The TÜV and UL certified or recommended dedicated power supply unit
SL-R11G:The safety relay is built-in. This is connected to the SL-CHG by a special connector.