KEYENCE LJ-H1W - Manual (Page 66)

Settings
5-2 LJ-H1W-M-NO5-E
Settings
This section describes the settings that can be configured in LJ-Navigator.
Select the tabs to switch between the settings.
Note Note
• Each setting can be configured for each program No.
• Send the settings to the controller after configuration is complete.
Head setting Trigger settings Configures the trigger settings that are common for Head A and
Head B.
Head A Sets the measurement conditions for Head A.
Head B Sets the measurement conditions for Head B.
Profile setup Configures the display settings for the acquired profile.
Master reg Registers the master profile that is used for calculation with the
calculation profile.
Pos corr Head A Sets the position correction for the displayed profile from Head A.
Head B Sets the position correction for the displayed profile from Head B.
OUT settings Sets the OUT conditions for OUT1 to OUT8.
Common TIMING terminal Sets TIMING1/TIMING2 for each OUT setting.
ZERO terminal Sets ZERO1/ZERO2 for each OUT setting.
Binary output Sets binary output for each OUT setting.
Analog output Sets the analog output conditions separately for CH1 and CH2.
Storage When storing data in the controller, select
either data storage or profile storage.
Auto-send Sets auto-send for each OUT setting.
Data out timing Sets the output timing for data.
Setting list Displays the list of the settings.