Brookfield R/S Coaxial Cylinder Rheometer - Manual (Page 50)

Brookfi eld Engineering Labs., Inc. Page 50 Manual No. M08-219-B1211
Deactivate “Carrier signal detection” check box (if crossed).
Finish input by pressing the OK key.
Select the menu option “Settings”
→ “Terminal Settings”
A window will appear where the user can set the terminal functions:
Select “English” option.
Activate “IBM in ANSI” (if not crossed yet).
Parameters of the terminal program that have been changed up to this time can be stored
under the menu option “File”
→ “Save” by entering the fi le name, e.g. “R/S+.TRM”. (When
the terminal program is started again, this fi le can be opened by: “File”
→ “Open” and load
the parameters for data transfer with the R/S+ Rheometer.
Now select the menu level “Transfer”
→ “Text fi le reception”.
Enter the fi le name of the stored data sent from the rheometer (e.g. “TEST.TXT”).
The message “Receiving: TEST.TXT” will then appear in the status line of the terminal
program.
The terminal program is now ready to receive data.
Start measurement with the rheometer. Measuring points should appear as text on the PC
display after a short period of time.
When the data of one or several measurements have been transferred into the selected text
fi le, terminate the data transfer and end the terminal program.
Should a receiver other than a PC be used for serial data transfer, the pin assignment of this
receiver must be checked before the connection is made. See Appendix A.3: Pin Assignment of
the Serial Data Cable to fi nd the pin assignment of the serial interface plug as well as of the data
link cable.
-
-
9.
-
-
10.
11.
-
-
12.
13.
14.