Brookfield R/S Coaxial Cylinder Rheometer - Manual (Page 30)

Brookfi eld Engineering Labs., Inc. Page 30 Manual No. M08-219-B1211
Example:
Select Meas.system:
1) DG DIN >
2) CC40
3) CC25 >
111
In the above screen, press OK to accept the DG DIN measuring system.
VI.4 Input of Numerical Values and Alphanumeric Texts
Most user defi ned entries are numbers. User defi ned values such as the Start and End values
of a ramp, number of measuring points, factors, time, date, etc. are entered as numbers with or
without decimal digits.
If the display shows the decimal point in a number to be entered, input of a fl oating-point number
is requested. However, the number of digits after the decimal point is limited to the number of
displayed decimal digits; i.e. the decimal point cannot be moved during input. The digit to be
changed is indicated by a bar under the digit.
The following examples indicate the input of numerical values. We will change the value of shear
rate (Val.[1/s]) from 0100.00 to 290.00.
In the example below, the cursor bar is located under the “1” in the entered shear rate (currently
100.00 s
-1 ).
Input of Values:
Val.[1/s]: 0100.00
Nr. of MP: 010
Time[s]: 0100
The “1” can be changed (incremented or decremented) by using the
and keys.
Press the
key once to get:
Input of Values:
Val.[1/s]: 0200.00
Nr. of MP: 010
Time[s]: 0100
The cursor can be moved right or left by using the
and keys. To change the next digit,
press the
key:
Input of Values:
Val.[1/s]: 0200.00
Nr. of MP: 010
Time[s]: 0100