Cisco 3825 - Manual (Page 268)

A-136
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
xconnect logging redundancy
xconnect logging redundancy
To enable system message log (syslog) reporting of the status of the xconnect redundancy group, use the
xconnect logging redundancy command in global configuration mode. To disable syslog reporting of
the status of the xconnect redundancy group, use the no form of this command.
xconnect logging redundancy
no xconnect logging redundancy
Syntax Description This command has no arguments or keywords.
Defaults Syslog reporting of the status of the xconnect redundancy group is disabled.
Command Modes Global configuration
Command History
Usage Guidelines Use this command to enable syslog reporting of the status of the xconnect redundancy group.
Examples The following example enables syslog reporting of the status of the xconnect redundancy group and
shows the messages that are generated during switchover events:
Router# config t
Router(config)# xconnect logging redundancy
Router(config)# exit
Activating the Primary Member
00:01:07: %XCONNECT-5-REDUNDANCY: Activating primary member 10.55.55.2:1000
Activating the Backup Member:
00:01:05: %XCONNECT-5-REDUNDANCY: Activating secondary member 10.55.55.3:1001
Related Commands
Release Modification
12.0(31)S This command was introduced.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB.
12.4(11)T This command was integrated into Cisco IOS Release 12.4(11)T.
12.4(16)MR This command was integrated into Cisco IOS Release 12.4(16)MR.
Command Description
xconnect Binds an Ethernet, 802.1q VLAN, or Frame Relay attachment circuit
to an L2TPv3 PW for xconnect service and enters xconnect
configuration mode.