Cisco 3825 - Manual (Page 206)

A-74
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
show cem circuit
show cem circuit
To display a summary of circuit emulation (CEM) circuits, use the show cem circuit command in the
privileged EXEC mode.
show cem circuit [cem-id]
Syntax Description
Command Modes Privileged EXEC
Command HistoryGl
Examples The following is an example of the output generated by this command.
Router# show cem circuit
CEM Int. ID Ctrlr Admin Circuit AC
--------------------------------------------------------------
CEM0/0/0 0 UP UP Enabled UP
CEM0/0/1 1 UP UP Enabled UP
CEM0/1/0 2 UP UP Enabled UP
CEM0/1/1 3 UP UP Enabled UP
CEM0/2/0 4 UP UP Enabled UP
CEM0/2/1 5 UP UP Enabled UP
Router# show cem circuit 5
CEM0/2/1, ID: 5, Line: UP, Admin: UP, Ckt: Enabled
Controller state: up
Idle Pattern: 0xFF, Idle cas: 0x8
Dejitter: 4, Sample Rate: 1, Payload Size: 192
Framing: Framed, (DS0 channels: 1-24)
CEM Defects Set
None
Signalling: No CAS
RTP: No RTP
Ingress Pkts: 527521938 Dropped: 0
Egress Pkts: 527521938 Dropped: 0
CEM Counter Details
Input Errors: 0 Output Errors: 0
Pkts Missing: 0 Pkts Reordered: 0
Misorder Drops: 0 JitterBuf Underrun: 0
Error Sec: 0 Severly Errored Sec: 0
Unavailable Sec: 0 Failure Counts: 0
Pkts Malformed: 0
cem-id (Optional) Identifies the circuit configured via the cem-group configuration
mode.
Release Modification
12.4(12)MR2 This command was introduced.