Cisco 3825 - Manual (Page 260)

A-128
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts-iub set dscp
umts-iub set dscp
To mark a packet by setting the differential services code point (DSCP) for UMTS-Iub value for the
backhaul packet including the peering and data generated from the shorthaul, use the umts-iub set dscp
Interface configuration command.
umts-iub set dscp value
Note Use this command when configuring UMTS shorthaul interfaces.
Syntax Description
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History
Examples The following example shows how to configure the parameters:
Router(config)# interface ATM0/2/0
Router(config-if) atm umts-iub
Router(config-if) umts-iub set dscp [value]
Related Commands
value A number from 0 to 63 or hex value that sets the UMTS-Iub DSCP value.
Release Modification
12.4(4)MR This command was introduced.
Command Description
umts-iub set peering dscp This command overwrites the interface default value defined in the
umts-iub set dscp value and is used to tag peering backhaul packet.