Cisco 3825 - Manual (Page 263)

A-131
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts local
umts local
To configure local ip address for the atm subinterfaces, use the umts local Sub-Interface configuration
command. This command is used when you want to off load PVC traffic from a physical ATM shorthaul
to an alternate backhaul. For each alternate backhaul, you need to create a logical shorthaul by creating
an atm subinterface. Traffic for the PVCs configured under this logical shorthaul will go through the
corresponding alternate backhaul.
umts local [ip-address]
Syntax Description
Command Modes Sub-Interface configuration
Command History
Examples The following example illustrates the use of the umts local command in Sub-Interface command mode.
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-subif)# atm umts
Router(config-subif)# umts local 10.10.10.2 5504
Note You do not need to input UDP port. The UDP port number will be inherited automatically from the base
atm interface’s umts remote [ip-address] [port] port configuration.
Related Commands
ip-address The IP address for the entry you wish to establish.
Release Modification
12.4(4)MR This command was introduced.
Command Description
atm umts This command enables the UMTS mode for alternate backhaul.
umts remote [ip-address] This command configures remote IP address for alternate backhaul.