Cisco 3825 - Manual (Page 168)

A-36
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
ima-group
ima-group
To define physical links as inverse multiplexing over ATM (IMA) group members, use the ima-group
Interface configuration command. When you first perform the configuration or when you change the
group number, the interface is automatically disabled, moved to the new group, and then enabled. To
remove the port from the group, use the no form of this command.
ima-group group-number
Syntax Description
Defaults Physical links are not included in IMA groups.
Command Modes Interface configuration
Command History
Usage Guidelines Use the ima-group interface command to configure a T1/E1 IMA port adapter interface as part of an
IMA group.
Examples The following example shows how to define an IMA group:
Router(config)# interface ATM0/0/0
Router(config-if)# no ip address
Router(config-if)# no atm ilmi-keepalive
Router(config-if)# ima-group 0
Related Commands
group-number Specifies an IMA group number from 0 to 3. IMA groups can span multiple
ports on a port adapter but cannot span port adapters.
Release Modification
12.0(5)XK This command was introduced.
12.4(4)MR This command was incorporated.
Command Description
interface atm Configures an ATM interface.
interface atm ima Configures an ATM IMA group.
show ima interface atm Provides information about configured IMA groups or a specific IMA
group.