Cisco 3825 - Manual (Page 259)

A-127
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts-iub remote
umts-iub remote
To configure the remote parameters required to establish an Internet Protocol/User Datagram Protocol
(IP/UDP) backhaul connection for use with the ATM path on the UMTS Iub interface, use the umts-iub
local Interface configuration command.
umts-iub remote [ip-address] [port]
Syntax Description
Defaults There are no default settings or behaviors.
Command Modes Interface configuration
Command History
Examples The following example shows how to configure the remote parameters:
Router(config)# interface ATM0/2/0
Router(config-if) atm umts-iub
Router(config-if) umts-iub remote 10.10.10.1 5502
Related Commands
ip-address (Optional) The IP address for the entry you wish to establish.
port (Optional) The port you want to use for the entry you wish to establish.
Release Modification
12.4(2)MR This command was introduced.
Command Description
umts-iub local Configures the local parameters for an IP/UDP backhaul
connection.