Cisco 3825 - Manual (Page 136)

A-4
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
atm umts
atm umts
To select an ATM interface for Universal Mobile Telecommunications System (UMTS) Iub traffic for
the atm subinterfaces, use the atm umts Sub-Interface configuration command. This command is used
when you want to off load one or more permanent virtual circuit (PVC) traffic packets from a physical
ATM shorthaul so as to go over an alternate backhaul. For each alternate backhaul, you need to create a
logical shorthaul by creating an atm subinterface. Traffic for the PVCs configured under this logical
shorthaul will go through the corresponding alternate backhaul.
atm umts
Syntax Description This command has no arguments or keywords.
Command Modes Sub-Interface configuration
Command History
Examples The following example illustrates the use of atm umts command.
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-subif)# atm umts
Note You can use this command only when the base atm interface is already enabled as atm umts.
Related Commands
Release Modification
12.4(4)MR This command is introduced.
Command Description
umts local [ip-address] This command configures the local IP address for alternate backhaul.
umts remote [ip-address] This command configures the remote IP address for alternate
backhaul.