Sample-rate – Cisco 3825 User Manual
Page 201
A-69
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
sample-rate
sample-rate
To specify in milliseconds the rate hardware samples the data on the attached circuit, use the
sample-rate command in the circuit emulation (CEM) circuit configuration mode.
sample-rate [sample-rate]
Syntax Description
Command Modes
CEM circuit configuration
Command History
Examples
The following example illustrates the use of the sample-rate command:
Router# config t
Router(config)# interface cem 0/0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# sample-rate 2
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands
sample rate
Sample rate translates into the payload-size sent over the circuit. The default
is 1 ms.
•
32-timeslots at 1ms = 256-bytes (32-timeslots * 8-bytes/timeslot/ms)
•
24-timeslots at 2ms = 384-bytes (24-timeslots * 16-bytes/timeslot/ms)
Release
Modification
12.4(12)MR2
This command was introduced.
Command
Description
cem
Apply CEM class.
cem class
Applies the CEM interface parameters defined in the given
class cem
Configure’s CEM interface parameters in a class that’s applied to
CEM interfaces together in the global configuration mode.