Cisco 3825 - Manual (Page 150)

A-18
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
dejitter-buffer
dejitter-buffer
To specify the size of the dejitter-buffer used to compensate for the network jitter, use the dejitter-buffer
command in the CEM configuration mode. To restore the dejitter-buffer to its default size, use the no form
of this command.
dejitter-buffer size
no dejitter-buffer
Syntax Description
Defaults The dejitter buffer defaults to 4 milliseconds.
Command Modes CEM circuit configuration
Command History
Examples The following example illustrates the use of the dejitter-buffer command:
Router# config t
Router(config)# interface cem 0/0/0
Router(config-if)# no ip address
Router(config-if)# cem 0
Router(config-if-cem)# dejitter-buffer 10
Router(config-if-cem)# xconnect 10.10.10.10 200 encapsulation mpls
Router(config-if-cem-xconn)# exit
Router(config-if-cem)# exit
Router(config-if)# exit
Router(config)# exit
Related Commands
size Use the size argument to specify the size of the buffer in milliseconds. Size
can vary from 4 to 500 ms; default is 4 ms.
Release Modification
12.4(12)MR2 This command was introduced.
Command Description
cem Enters circuit emulation configuration mode.
cem class Applies the CEM interface parameters defined in the given
to the circuit.
class cem Configure’s CEM interface parameters in a class that’s applied to
CEM interfaces together in the global configuration mode.