Cisco 3825 - Manual (Page 264)

A-132
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
umts remote
umts remote
To configure local ip address for the atm subinterfaces, use the umts remote Sub-Interface configuration
command. This command is used when you want to off load one or more PVC’s traffic from a physical
ATM shorthaul to go over alternate backhaul. For each alternate backhaul, you need to create a logical
shorthaul by creating an atm subinterface. Traffic for the PVCs configured under this logical shorthaul
will go through the corresponding alternate backhaul.
umts remote [ip-address]
Syntax Description
Command Modes Sub-Interface configuration
Command History
Examples The following example illustrates the use umts remote command.
Router(config)# interface ATM0/2/0
Router(config-if)# atm umts-iub
Router(config-subif)# atm umts
Router(config-subif)# umts remote 10.10.10.1 5502
Note The port number will be inherited from the base ATM interfaces’s remote port number.
Related Commands
ip-address The IP address for the entry you wish to establish.
Release Modification
12.4(4)MR This command was introduced.
Command Description
atm umts This command enables the UMTS mode for alternate backhaul.
umts local [ip-address] This command configures the remote IP address for alternate
backhaul.