Cisco 3825 - Manual (Page 183)

A-51
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
ipran-mib location
ipran-mib location
Use the ipran-mib location command in the global configuration mode to define the location of the
device. It is also used to assist the network management system in properly displaying the topology of
the system.
ipran-mib location location
Syntax Description
Defaults cellSite.
Command Modes Interface configuration
Command History
Examples
Router# config t
Router(config)# ipran-mib location aggSite
Router(config)# ipran-mib location cellSite
Router(config)# ipran-mib location undefined
Router(config)# no ipran-mib location
Router(config)# exit
Related Commands
ipran-mib location ? • addSite located at BSC or RNC site.
• cellSite Located at BTS or Node B site.
• undefined Undefined location.
Release Modification
12.4(2)MR1 This command was introduced.
12.4(9)MR Support for utilization notification was removed. This command is supported to
maintain compatibility.
Command Description
ipran-mib snmp-access Defines the type of connectivity between the device and the network
management system.