Cisco 3825 - Manual (Page 248)

A-116
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
snmp-server enable traps ipran alarm-gsm
snmp-server enable traps ipran alarm-gsm
To provide information alarms associated with GSM-Abis interfaces via Simple Network Management
Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps
ipran alarm-gsm command in global configuration mode. To disable ipran alarm-gsm notifications, use
the no form of this command.
snmp-server enable traps ipran alarm-gsm
no snmp-server enable traps ipran alarm-gsm
This statement controls the generation of the cisco IpRanBackHaulGsmAlarm notification from the
CISCO-IP-RAN-BACKHAUL-MIB.
Syntax Description This command has no arguments or keywords.
Defaults This command is disabled by default. No notifications are sent.
Command Modes Global configuration
Command History
Examples The following is an example of the output generated by this command.
Router(config)# snmp-server enable traps ipran alarm-gsm
Related Commands
Release Modification
12.4(2)MR1 This command was introduced.
Command Description
snmp-server enable traps
ipran alarm-umts Provides information alarms associated with UMTS-Iub interfaces.
snmp-server enable traps
ipran util Provides information on backhaul utilization.
snmp-server enable traps
ipran Enables all notifications.