Cisco 3825 - Manual (Page 249)

A-117
Cisco 3825 Mobile Wireless Edge Router Software Configuration Guide
OL-15667-03
Appendix A Cisco 3825 Mobile Wireless Edge Router RAN-O Command Reference
snmp-server enable traps ipran alarm-umts
snmp-server enable traps ipran alarm-umts
To provide information alarms associated with UMTS-Iub interfaces via Simple Network Management
Protocol (SNMP) notifications (traps) available on your system, use the snmp-server enable traps
ipran alarm-umts command in global configuration mode. To disable ipran alarm-umts notifications,
use the no form of this command.
snmp-server enable traps ipran alarm-umts
no snmp-server enable traps ipran alarm-umts
This statement controls the generation of the cisco IpRanBackHaulUmtsAlarm notification from the
CISCO-IP-RAN-BACKHAUL-MIB.
Syntax Description This command has no arguments or keywords.
Defaults This command is disabled by default. No notifications are sent.
Command Modes Global configuration
Command History
Examples The following is an example of the output generated by this command.
Router(config)# snmp-server enable traps ipran alarm-umts
Related Commands
Release Modification
12.4(2)MR1 This command was introduced.
Command Description
snmp-server enable traps
ipran alarm-gsm Provides information alarms associated with GSM-Abis interfaces.
snmp-server enable traps
ipran util Provides information on backhaul utilization.
snmp-server enable traps
ipran Enables all notifications.