Panasonic AG-DTL1P - Manual (Page 76)

RS-232C
Time lapse control commands
These commands are not acknowledged while a search control command is being processed.
Data transmitted by PC Data returned from unit in response Description of command
[STX] LBR:m [ETX]
Parameter
m = N: Buzzer ON
F: Buzzer OFF
[STX] LBR [ETX] Sets whether the buzzer is to sound when REC REVIEW
reveals that the proper video level was not maintained.
[STX] LBZ:m [ETX]
Parameter
m = N: Buzzer ON
F: Buzzer OFF
[STX] LB2 [ETX] Sets whether the buzzer is to sound during alarm recording
and sensor recording.
[STX] LMS:m [ETX] [STX] LMS [ETX]
Parameter
m = 0:
1 second
1: 1.5 seconds
2: 2 seconds
3: 2.5 seconds
4; 3 seconds
5: 4 seconds
6: 5 seconds
7:
10 seconds
Sets the timing at which to switch the video signals which
are supplied from the camera and which are to be output
from the rear panel VIDEO OUT connector.
[STX] LDA;m [ETX]
Parameter
m = C: CONTINUE
Control signals continue to
be output even after
recording,
A: ALARM REC
Control signals are output
only during alarm recording
and sensor recording.
[STX] LDA [ETX] Sets how the control signals are to be output to the
component connected to ALARM OUT on the rear panel
terminal section when alarm recording or sensor recording
is performed.
[STX] LDF:m [ETX]
Parameter
m = I: Field recording
R: Frame recording
[STX] LDF [ETX] Sets whether field recording or frame recording is to be
performed for alarm recording and sensor recording.
[STX] LDM:m [ETX]
Parameter
m = F: OFF
Alarm signal input is
ignored.
M: ALARM/SENSOR
Alarm recording or sensor
recording is performed.
A: ALARM
Alarm recording is
performed.
S: SENSOR
Sensor recording is
performed.
[STX] LDM [ETX] Sets what recording is to be performed when an alarm
signal has been input.
76