Panasonic AG-DTL1P - Manual (Page 67)

RS-232C
Media operation control commands
Data transmitted by PC Data returned from unit in response Description of command
[STX] HEA [ETX] [STX] HEA [ETX] Sets the operation that is to take place when the EJECT
button is pressed to REW 4 EJECT (tape is ejected after it
has been rewound to its start position).
This command is not acknowledged while a search control
command is being processed.
[STX] НЕЕ [ETX] [STX] НЕЕ [ETX] Sets the operation that is to take place when the EJECT
button is pressed to EJECT.
This command is not acknowledged while a search control
command is being processed.
[STX] HRE:m [ETX]
Parameter
m = B: BUZZER
E: EJECT
P: REPEAT
R: REWIND
S: STOP
[STX] HRE [ETX] Sets the unit’s operation mode that is to be established
when the tape-end is reached during recording.
This command is not acknowledged while a search control
command is being processed.
[STX] HRL:m [ETX]
Parameter
m = F: Recording enabled
N: Recording disabled
[STX] HRL[ETX] Sets the lock mode for operation during recording.
[STX] HTI:m [ETX]
Parameter
m= A: REWIND^ REC
R: REC
S; STOP
[STX] HTI [ETX] Sets the unit’s operation mode that is to be established
when the tape has been inserted.
This command is not acknowledged while a search control
command is being processed.
[STX] HTR:m:b [ETX]
Parameter
m = 0: 2% of tape remaining
1: 10% of tape remaining
2: 20% of tape remaining
3: 30% of tape remaining
F: (OFF) no warning
b = N: Warning is sounded by
buzzer.
F: (OFF) warning is not
sounded by buzzer.
[STX] HTR [ETX] Sets the remaining tape amount for which REMAIN is to
flash on the display tube as a warning display, and sets the
buzzer to sound when the tape-end position is about to be
reached. (When a 120-minute tape is used)
67