Panasonic AG-DTL1P - Manual (Page 75)

RS-232C
I Time lapse control commands
These commands are not acknowledged while a search control command is being processed.
Data transmitted by PC Data returned from unit in response Description of command
[STX] LAD:m [ETX] [STX] LAD [ETX] Sets the time during which alarm recording or sensor
Parameter recording is to be performed.
m = 0 30 seconds
1 1 minute
2 1 minute and 30 seconds
3 2 minutes
4 3 minutes
5 6 minutes
6 10 minutes
7
8
CONTINUE:
Recording continues until
the tape-end.
MANUAL:
Recording only while an
alarm signal is input.
[STX] LAI:m [ETX] [STX] LAI [ETX] Sets the operation mode that is to be established when an
Parameter
m = S: STOP
alarm signal has been input at the tape-end position.
Stop mode established at
tape-end position.
C: CONTINUE
Alarm signal input is
ignored.
[STX] LAR [ETX] [STX] LAR [ETX] Deletes the ALARM RECALL data.
[STX] LBM:m [ETX] [STX] LBM [ETX] Sets the processing to be performed for the black burst
Parameter signal when the video signals to be output from the video
m = N; ON signal output connectors are switched.
F
Output of the black burst
signal.
OFF
No output of the black burst
signal.
[STX] LBP:m [ETX] [STX] LBP [ETX] Prevents the video signals of the camera designated by the
Parameter parameter from being output from the VIDEO OUT
m = +
0
: Video signals of all the
cameras are output.
Camera 1
connector.
1
2
3
Camera 2
Camera 3
Camera 4
4: Camera 5
5
6
7
8
9 Camera 6
Camera 7
Camera 8
Camera 9
Camera 10
A: Camera 11
B: Camera 12
C; Camera 13
D: Camera 14
E
F : Camera 15
: Camera 16
1
75