Dynon Avionics SkyView System Installation Guide - Manual (Page 75)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
SkyView System Installation Guide – Revision S 4-13
a. Power down all displays except #1. Verify all serial port devices are working -
transponder, GPS, radios, etc.
b. Power down all displays except #2. Verify all serial port devices are working -
transponder, GPS, radios, etc.
c. Power down all displays except #3. Verify all serial port devices are working -
transponder, GPS, radios, etc.
A SkyView Display serial port can be configured to communicate with one device
on its TX and a different device on its RX, but when doing so, the TX and RX speeds
must be the same.
Table 10 contains serial port wire functions and wire harness colors.
Serial Port Wire Function
SkyView Display Harness
Wire Colors
1
TX Brown with Orange stripe
RX Brown with Violet stripe
2
TX Yellow with Orange stripe
RX Yellow with Violet stripe
3
TX Green with Orange stripe
RX Green with Violet stripe
4
TX Blue with Orange stripe
RX Blue with Violet stripe
5
TX Gray with Orange stripe
RX Gray with Violet stripe
SV-GPS-250
Power
Solid Orange
SV-GPS-250
Ground
Solid Black
Table 10 – SkyView Serial Port Connections
Traffic Devices
SkyView has the ability to receive aircraft traffic information from different devices, including
the SV-XPNDR-261/262, the Zaon XRX (with the ZAON set to “Garmin” output), the Garmin GTX
330 / 330ES transponders, and the Garrecht TRX-1500 (set to TIS output). If a device that can
provide traffic is connected to SkyView and configured (usually as a TIS serial traffic device
under SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP), further traffic display options can
be configured in SETUP MENU > TRAFFIC SETUP. The traffic display on both the PFD and MAP
pages can be set to include just Traffic Advisories (TA), all targets, or no targets.