Dynon Avionics SkyView System Installation Guide - Manual (Page 127)

SV-EMS-220/221 Installation and Configuration
SkyView System Installation Guide – Revision S 7-15
Example Lycoming/Continental 4-cylinder Fuel Injected (SV-EMS-220)
Pin
EMS 37-pin Harness
Wire Color
Sensor (with Dynon part number if
applicable)
1 Red Battery voltage (voltmeter input)
2 Yellow or Unwired Not connected
3 Black Ground
4 Violet/Blue Elevator position potentiometer
5 Black Ground
6 White/Yellow Oil pressure (100411-002 or 101693-000)
7 White/Brown Oil temperature (100409-000)
8 Brown Fuel pressure (100411-001 or 101716-000)
9 Brown/Blue Heated pitot status (contact input)
10 Brown/Yellow Not connected
11 Orange Not connected
12 Yellow Not connected
13 Black Ground
14 Yellow Fuel flow (100403-003)
15 Red Fuel flow power (100403-003)
16 Black Ground
17 Black Ground
18 White/Red
Manifold Pressure Sensor Power (+5 volt) /
Kavlico Pressure Sensors
19 White/Black Not connected
20 Orange/Brown Fuel level left (resistive)
21 Orange/Blue Fuel level right (resistive)
22 Violet/Yellow Flaps position potentiometer
23 Violet/Green Not connected
24 Orange/Green Ammeter shunt + (100412-000)
25 Orange/Violet Ammeter shunt -
26 Green/Red Manifold Pressure (100434-000)
27 Open Not connected
28 Open Not connected
29 Yellow/Green Optional External Alarm Light
30 Black Not connected
31 White/Orange Not connected
32 White/Green RPM Left (standard)
33 White/Blue RPM Right (standard)
34 Blue Not connected
35 Green Not connected
36 Blue or Unwired Not connected
37 Green or Unwired Not connected
Table 20 – Example Lycoming/Continental 4-cylinder Fuel Injected 37-pin Connector Sensor Map