Dynon Avionics SkyView System Installation Guide - Manual (Page 251)

SV-ARINC-429 Installation and Configuration
SkyView System Installation Guide – Revision S 12-9
SkyView Settings
SETUP MENU > SYSTEM SETUP > ARINC-429:
(Configure MODULE 1 and MODULE 2 independently)
> INPUT SPEED: HIGH
> INPUT 1: GPS X
> NAVIGATION SOURCE DISP NAME: (user selectable, 7 characters. The name entered here is
displayed as the HSI source and the Flight Plan Source (if this device outputs a flight plan).
> INPUT 2: NAV X
> NAVIGATION SOURCE DISP NAME: (user selectable, 7 characters. The name entered here is
displayed as the HSI source and the Flight Plan Source (if this device outputs a flight plan).
> OUTPUT SPEED: HIGH
> ALLOW AUTO SWITCH: YES (LABEL 100P)
Setting ALLOW AUTO SWITCH: to YES (LABEL 100P) (which is the default, including after
upgrading firmware to v10.0 or later) allows the GTN to tell SkyView to switch from GPS to ILS
or back when on an ILS overlay approach - SkyView will display whatever mode the GTN tells
SkyView to be in. When in this mode and not on an approach, switching between the NAV
function and GPS function must be performed from the GTN.
If you want to manually select GPS and NAV from the GTN, as you have done prior to v10.0,
SETUP MENU > SYSTEM SETUP > ARINC-429 > ALLOW AUTO SWITCH: NO.