Dynon Avionics SkyView System Installation Guide - Manual (Page 139)

SV-EMS-220/221 Installation and Configuration
SkyView System Installation Guide – Revision S 7-27
Example
Rotax
912 iS
(SV-
EMS-
221)Pin
EMS 37-pin Harness
Wire Color
Sensor (with Dynon part number if
applicable)
7 White/Brown Not connected
8 Brown Fuel pressure (101716-000)
9 Brown/Blue Not connected
10 Brown/Yellow Not connected
11 Orange Not connected
12 Yellow Flaps position potentiometer
13 Black Available ground
14 Yellow Fuel flow (100403-003)
15 Red
Fuel flow power (100403-003) / Oil pressure
(Honeywell and Rotax P/N 456180 only) sensor
power
16 Black Available ground
17 Black Available ground
18 White/Red
Manifold Pressure Sensor Power (+5 volt) / Kavlico
Pressure Sensors
19 White/Black Return fuel flow (100403-003)
20 Orange/Brown Fuel level left (resistive)
21 Orange/Blue Fuel level right (resistive)
22 Violet/Yellow Not connected
23 Violet/Green Elevator position potentiometer
24 Orange/Green Ammeter shunt + (100412-000)
25 Orange/Violet Ammeter shunt -
26 Green/Red Not connected
27 Open
RPM Signal to Rotax 912 iS Prop Controller
(optional)
28 Open
NOTE: Must be grounded to common ground with
Prop Controller
29 Yellow/Green Optional External Alarm Light
30 Black Not connected
31 White/Orange Not connected
32 White/Green Not connected
33 White/Blue Not Connected
34 Blue Not connected
35 Green Not connected
36 Blue or Unwired CAN High from 912 iS ECU
37 Green or Unwired CAN Low from 912 iS ECU
Table 32 – Example Rotax 912 iS 37-pin Connector Sensor Map
The 912 iS ECU provides the following information to SkyView via a computerized CAN bus
interface: