Dynon Avionics SkyView System Installation Guide - Manual (Page 24)

System Planning
2-2 SkyView System Installation Guide - Revision S
Power Consumption
Table 2 contains power specifications for typical SkyView systems. Note that SkyView displays
(SV-D700, SV-D1000, SV-D1000T) provide power to SV-ADAHRS-200/201, SV-EMS-220/221, SV-
ARINC-429, SV-KNOB-PANEL, the “control panel section” of SV-AP-PANEL, and the SV-GPS-250.
Thus the individual power requirements of those units are not shown; their power
requirements are included in the power requirements of the SkyView display(s). When there
are two SkyView displays in a system, both displays “share the load” of powering SkyView
Network modules.
Unit
Current
requirement
@ 12 volt DC
no
SV-BAT-320
Current
requirement
@ 12V DC
with
SV-BAT-320
Current
requirement
@ 24V DC
no
SV-BAT-320
Current
requirement
@24V DC
with
SV-BAT-320
Circuit
Breaker
Recommendation
SV-D700
display S/N
below 4000
3.17A
(maximum)
4.67A
(maximum
when charging)
1.59A
(maximum)
2.34A
(maximum
when charging)
5A
SV-D700
display S/N
above 4000
2.77A
(maximum)
4.27A
(maximum
when charging)
1.39A
(maximum)
2.14A
(maximum
when charging)
5A
SV-D1000
display S/N
below 6000
3.5A
(maximum)
5.0A
(maximum
when charging)
1.75A
(maximum)
2.5A
(maximum
when charging)
5A
SV-D1000
Display S/N
above 6000
3.1A
(maximum)
4.6A
(maximum
when charging)
1.55A
(maximum)
2.3A
(maximum
when charging)
5A
SV-D1000T
display
(all S/N)
3.1A
(maximum)
4.6A
(maximum
when charging)
1.55A
(maximum)
2.3A
(maximum
when charging)
5A
Table 2 – SkyView Display Power Specifications