Dynon Avionics SkyView System Installation Guide - Manual (Page 114)

SV-EMS-220/221 Installation and Configuration
7-2 SkyView System Installation Guide - Revision S
Choose a
location based on
Location
Requirements
Section
Install SkyView
network cabling
Prepare the
location
Install engine
sensors and
transducers
Install EMS
module with
electrical
connections
Configure
EMS-related
settings on
SkyView display
Perform
EMS-related
calibrations
*Assumes SV-D700 or SV-D1000 is properly installed and working.
Plan sensor and
transducer
installation
Obtain wire
harnesses,
sensors,
transducers, etc.
Research Dynon
presupported
engine
installations
Understand
presupported
engine
installation
Install
EMS-specific wire
harnesses
Configure
SkyView Network*
Engine
presupported?
Yes
No
Check for and install
EMS sensor definition
and configuration file
updates
Figure 27 – Suggested SV-EMS-220/221 Installation and Configuration Procedure