Dynon Avionics SkyView System Installation Guide - Manual (Page 64)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
4-2 SkyView System Installation Guide - Revision S
Physical Installation
SV-D700 Installation Dimension Quick Overview

Panel Cutout: 6.97” x 5.35” (117.038 mm x 135.890mm)

Bezel Outline: 7.636” x 5.512” (193.954 mm x 140.005 mm)
SV-D1000 / SV-D1000T Installation Dimension Quick Overview

Panel Cutout: 9.68” x 6.90” (245.872mm x 175.260mm)

Bezel Outline: 10.320” x 7.064”(262.128mm x 179.426mm)
For those upgrading from a D100 series product, note that the SV-D700 display has
a slightly larger cutout than those products.
Figure 17 and Figure 18 on the following pages show recommended panel cutouts and
mounting hole patterns for SV-D700 and SV-D1000 displays. Note that the SkyView 7" display
has a smaller cutout size and fewer mounting holes than the SkyView 10" display.
Figure 19 and Figure 20 on the following pages show the mechanical dimensions of the SkyView
displays. Use the dimensions (in inches) found in the appropriate diagram to plan for the space
required by the display.
To mount a SkyView display, cut an appropriately sized rectangular opening in your panel, drill
out the mounting holes, and use the included mounting screws to fasten the display to the
panel.
SkyView displays are shipped with #6-32 hex-drive round head fasteners. Fasteners are 5/8” in
length and require a 5/64” hex drive tool. Dynon recommends fastening the included mounting
screws to nut plates installed behind the panel. If access behind the panel allows, standard #6-
32 lock nuts or nuts with lock washers can be used. Do not rivet the SkyView display to the
aircraft as this will hinder future removal if necessary.