Dynon Avionics SkyView System Installation Guide User Manual
Page 332
18-8
SkyView System Installation Guide - Revision S
> MOTOR 1:
> AUTO-TRIM FUNCTION: NONE (right click to enter the menu)
Follow the on-screen instructions to define which trim surface the Autopilot auto-trim
feature will move. This process also determines the correct auto-trim motor directions.
Pushing the RESET button will restart the calibration process.
After the calibration is complete, the AUTO-TRIM FUNCTION: (label) will reflect the trim
surface that will be automatically trimmed by the autopilot when that autopilot axis is
engaged.
> QUICKEST TRIM SPEED
> TRIM MOTOR SPEED: xxx%
Set as appropriate for your aircraft’s performance.
> AT AND BELOW AIRSPEED: xxx KNOTS
Set as appropriate for your aircraft’s performance.
> SLOWEST TRIM SPEED
> TRIM MOTOR SPEED: xxx%
Set as appropriate for your aircraft’s performance.
> AT AND ABOVE AIRSPEED: xxx KNOTS
Set as appropriate for your aircraft’s performance.
(If you connected trim control pushbuttons and the motors per Table 65 above, MOTOR 2 will
control ROLL trim.)
> MOTOR 2 CONFIG:
> AUTO-TRIM FUNCTION: NONE (right click to enter the menu)
Follow the on-screen instructions to define which trim surface the Autopilot auto-trim
feature will move. This process also determines the correct auto-trim motor directions.
Pushing the RESET button will restart the calibration process.
After the calibration is complete, the AUTO-TRIM FUNCTION: (label) will reflect the trim
surface that will be automatically trimmed by the autopilot when that autopilot axis is
engaged.
> QUICKEST TRIM SPEED
> TRIM MOTOR SPEED: xxx%
Set as appropriate for your aircraft’s performance.
> AT AND BELOW AIRSPEED: xxx KNOTS
Set as appropriate for your aircraft’s performance.
> SLOWEST TRIM SPEED