Dynon Avionics SkyView System Installation Guide - Manual (Page 370)

Appendix C: Wiring and Electrical Connections
22-12 SkyView System Installation Guide - Revision S
SV-EMS-221 D37
Pin
EMS 37-pin Harness Wire
Color
Sensor (with Dynon part number if
applicable)
1 Red Voltmeter 1 (0 to 30 volts DC)
2 Yellow or Unwired Voltmeter 2 (0 to 30 volts DC)
3 Black Signal Ground
4 Violet/Blue General Purpose Input 1
5 Black Signal Ground
6 White/Yellow General Purpose Input 11
7 White/Brown General Purpose Input 12
8 Brown Enhanced General Purpose Input 4
9 Brown/Blue General Purpose Input 5
10 Brown/Yellow General Purpose Input 6
11 Orange General Purpose Input 7
12 Yellow General Purpose Input 8
13 Black Signal Ground
14 Yellow Fuel Flow Input 1
15 Red +12 volts DC Auxiliary Power Output
16 Black Signal Ground
17 Black Signal Ground
18 White/Red
+5 volts DC Auxiliary Power Output
(Limited to 300 mA by internal self-
resetting fuse)
19 White/Black Fuel Flow Input 2
20 Orange/Brown General Purpose Input 9
21 Orange/Blue General Purpose Input 10
22 Violet/Yellow Enhanced General Purpose Input 2
23 Violet/Green Enhanced General Purpose Input 3
24 Orange/Green Amps+ Input
25 Orange/Violet Amps- Input
26 Green/Red Manifold Pressure Input
27 Open
RPM Signal to Rotax 912 iS Prop Controller
(optional)
28 Open
NOTE: Must be grounded to common
ground with Prop Controller
29 Yellow/Green Optional External Alarm Light
30 Black Signal Ground
31 White/Orange Enhanced General Purpose Input 13
32 White/Green Standard RPM Left Input
33 White/Blue Standard RPM Right Input
34 Blue Low Voltage RPM Left Input
35 Green Low Voltage RPM Right Input
36 Blue or Unwired CAN High from 912 iS ECU
37 Green or Unwired CAN Low CAN High from 912 iS ECU
Table 78 – SV-EMS-221 Male D37 Transducer Connector