Dynon Avionics SkyView System Installation Guide - Manual (Page 183)

SV-EMS-220/221 Installation and Configuration
SkyView System Installation Guide – Revision S 7-71
Example Oil Temperature Sensor Setup
Assume this sensor was mapped on the Sensor Input Mapping Wizard as:
PIN # FUNCTION SENSOR NAME
C37 P7 TEMPERATURE 5/8”-18 NPT FLUID TEMP (100409-000) OIL
Now, we want to configure its alert and graphical properties. Go to the Sensor Setup Menu and
open the OIL TEMPERATURE Page (SETUP MENU > EMS SETUP > SENSOR SETUP > OIL
TEMPERATURE).
Configure OIL TEMPERATURE with the following properties:

ALARM: LATCHING

MAXIMUM GRAPHICAL DISPLAY: 260 °F

MINIMUM GRAPHICAL DISPLAY: 80 °F

SHOW SENSOR UNITS YES

RANGE 1
o ENABLE YES
o COLOR YELLOW
o TOP 165 °F
o BOTTOM 80 °F

RANGE 2
o ENABLE YES
o COLOR GREEN
o TOP 220 °F
o BOTTOM 165 °F

RANGE 3
o ENABLE YES
o COLOR YELLOW
o TOP 240 °F
o BOTTOM 220 °F

RANGE 4
o ENABLE YES
o COLOR RED
o TOP 260 °F
o BOTTOM 240 °F

RANGE 5
o ENABLE NO
o COLOR RED
o TOP 5 °F
o BOTTOM 0 °F
Note that oil temperature is configured with a latching alarm in this example. If oil
temperature ever reaches a range configured as red, an alarm will trigger and a
Figure 50 –
Anatomy of a
Widget: Oil
Temperature