B&C Technologies DI-325 Industrial - Manual (Page 69)

OPERATING AND PROGRAMMING INSTRUCTIONS
8-38
(34) Maintenance request
The maintenance request counter is 0 and the machine needs maintenance. The number of
batches which can be done between 2 maintenance requests is adjustable with machine parameter
5). Resetting the maintenance request can be done via the ‘System Set-up’ menu (see chapter 6.6.4).
(36) Waiting for cycle restart
While a program was running the machine was stopped, either by an alarm or by pushing
the stop button. If the start button is pushed the machine will continue its cycle. If the stop button is
pushed the program cycle will be stopped.
(37) Program finished
A program is finished. If the door is opened the machine will finish and start from the
beginning again.
(38) Press to start
The machine is ready to start a new program. If the start button is pushed, and all inputs are
okay, a program cycle will start.
8 Default settings and default programs
When the DQ 01 controller is delivered, or when factory settings are recalled (see chapter
6.6.3), default programs and default machine parameters will be available.
8.1 Default program settings and default programs
Because the used language can vary, no default program names are set, except for program
100, which will be called ‘Single cycle’.
All programs are set to the following default values:
01
Drying method TIME
03 Min. drying time 10 m
04 Max. Drying time 45 m
05 Drying time 40 m
07 Dry temperature 167 °F / 75 °C
08 Offset sensor 2 2 °F / °C
09 Offset infrared 4 °F / °C
10 Humidity dry val. 15%
18 Cooldown time 10 m
19 Cooldown temp. 95 °F / 35 °C
23 Drum direction REV
24 Drum speed 100 %
25 Drum stop time 1 s
26 Drum run time 45 s
29 Anti crease funct. YES
32 Max. temp. rise 0 °/m
33 Max. temp. fall 0 °/m
In the default programs, some parameter values are set to a different value to provide
different programs to start with. The following default programs are available: